Technical assistance

We want to clear the main technical questions that may arise about the operation of our products and the steps necessary for their assembly.

Last questions:

In order to change the handles on a piece of furniture for other new ones, it is necessary to take into consideration the measurements of the holes in order to make the most of them. With single hole handles, it is simple and you can choose any model as it will coincide. If, on the contrary, you have more than one hole, you have to measure from centre to centre of the hole. This measurement is what will determine the handle that you need in order to be able to easily install it without having to drill new holes.Check that the measurement is a multiple of 32mm, as they are normally 32, 64, 96, 128, 160, 192, etc. If that is not the case, it will be necessary to have a special handle measure or cover up the holes of the previous handle with a product designed for that purpose. You need to bear in mind possible marks that have been created over time. A handle provides doors with a new look and it is a great solution for adding a new touch to a piece of furniture for a very low cost

The maximum recommended length of the installation of LED strips is indicated in our catalogue with a symbol on each LED strip.The table outlines the maximum recommended length if the power supply is only provided via one length (a converter). It also outlines the maximum recommended length if the power supply is provided via both ends (two converters) that multiply by two.Please note: To power the strip via both ends you need to create a special connection. Look up how can to ensure that the LED strip has the same brightness all along it.

Documents:

Download

This light has a range of 600 switching cycles per charge before the battery runs out and it has an LED indicator that goes from red to green when the charge is complete following an approximate time of 2 hours.

The charging time will vary depending on the amperage of the charger. It is recommended to use 5V DC 1A chargers, therefore the estimated charge time is 2 hrs.

Yes, it is possible to recharge the Rigel light with a mobile phone charger. The charger needs to have a type B micro USB and should at least supply 5V DC 0,5A.

This light has a range of 400 switching cycles per charge before the battery runs out and it has an LED indicator that goes from red to green when the charge is complete following an approximate time of 2 hours.

The charging time will vary depending on the amperage of the charger. It is recommended to use 5V DC 1A chargers, therefore the estimated charge time is 2 hrs.

Yes, it is possible to recharge the Kaus light with a mobile phone charger. The charger needs to have a type C micro USB and should at least supply 5V DC 1A.

Subscribe to notifications
You're subscribed to notifications
You've blocked notifications
Click to subscribe to notifications
Thanks for subscribing!
You're subscribed to notifications
You won't receive notifications again
Manage Site Notifications
SUBSCRIBE
UNSUBSCRIBE
Unblock Notifications
Follow these instructions to allow notifications: